Koden CVS-872D, Installation Manual

Page: 57 / 112

CVS-872D Chapter 1 Installation
0092607062-01 1-39
In the case of connection of CVS-872D and transducer (TDM-091D/TDM-031D/
TDM-041D/TDM-071):
1) Refer to the connection table of transducers, solder CW-836-3M and CW-844-3M to the
transducer. After soldering is completed, be sure to provide the connected part with water
resistance and insulation using self-adhesive tape, etc.
2) Connect CW-836-3M after the above processing to J7 connector of CVS-872D.
Connect CW-844-3M after the above processing to J6 connector of CVS-872D.
Fig. 1.32 Connection of transducer cable
Connection table of transducer
Caution:
Wind the insulation tape around the un-used lead wire for core-wires not to
contact each other.
Connectors to be connected
Connectors to be
connected from
CW-836-3M J7
Connectors to be
connected from
CW-844-3M J6
Transducer
cable
Note
No. J6
Color of
cable
Name of
signal
Color of
cable
Name of
signal
Color of
cable
4 Shield - - Shield Shield Shield (In)
Water
temp.
sensor
6
Green/
Water temp. sensor power
- - Green
Water temp.
sensor
White
7
Red/
Water temp. sensor input
- - Red
Water temp.
sensor
Brown
3
Orange/XID Data - - Orange - Orange, XID
1 Blue/NC - - Blue - -
2
White/NC - - White - -
8
Black/XID GND - - Black - Shield (Out) XID
No.
J7
3
Shield Shield
Housing
GND
- - Shield
5
Black/TD2L
(Low frequency transducer)
Black TD2L - - -
2
White/TD1L
(Low frequency transducer)
White TD1L - - -
4
Green/TD2H
(High frequency transducer)
Green TD2H - - Black
High
frequency
1
Red/TD1H
(High frequency transducer)
Red TD1H - Blue
Solder
ed
CW-836-3M
XID-adaptive TD cable
To J7 connector of
CVS-872D
CW-844-3M
Solder
ed
To J6 connector of
CVS-872D
TDM-091D
TDM-031D
TDM-041D
TDM-071
Shield
Green
Red
Orange
Black
White
Blue
Shield
Green
Red
Black
White
Shield (In)
White
Brown
Orange
Shield (Out)
Shield
Black
Blue