Koden CVS-872D, Installation Manual

Page: 61 / 112

CVS-872D Chapter 1 Installation
0092607062-01 1-43
Connection of Single frequency type Transducer
In the case of connection of CVS-872D and single frequency type transducer:
1) Refer to the connection table of transducers, solder CW-836-3M and CW-844-3M to the
transducer. After soldering is completed, be sure to provide the connected part with water
resistance and insulation using self-adhesive tape, etc.
2) Connect CW-836-3M after the above processing to J7 connector of CVS-872D.
Connect CW-844-3M after the above processing to J6 connector of CVS-872D.
*The ferrite transducer should be connected to the resonance capacitor.
Fig. 1.36 Connection of transducer cable
Connection table of Water temp. sensor
CVS-872D
J6
Cable
CW-844-3M Remarks
No. Signal name Wire color
4 Shield Shield
For Water temp. sensor
6 Water temp. sensor power Green
7 Water temp. sensor input Red
3 NC Orange
NC
1 NC Blue
2 NC White
8 NC Black
CW-836-3M
CVS-872D
To J7
CW-844-3M
CVS-872D
To J6
NC
To Water temp. sensor
White
Black
Shield
White
Black
TD cable
Low frequency TD
High frequency TD
*
*
NC
NC
NC
Shield
Green
Red
Orange
Blue
White
Black
Black
White
Shield
Green
Red