Koden CVS-705D, Installation Manual

Page: 37 / 74

CVS-705D/707D Chapter 1 Installation
0092607052-03 1-17
Fig. 1.19 Pins assignment of rear connector-2
: The external monitor connector (D-Sub 15 pin) is available only for CVS-707D.
In case an external monitor is connected to CVS-705D, use the J5 connector.
(Refer to P1-24
“Connection of External Monitor”)
Connection of power cable (CW-270-2M)
Connect the power cable to the [POWER] connector at the rear of the Display unit
(CVS-705D) or rear of Processor unit (CVS-707D).
Connection of DC power cable (CW-270-2M)
Fig. 1.20 Connection of DC power cable
Caution:
Wind the insulation tape around the un-used lead wire for core-wires not to
contact each other.
Caution:
Confirm the main switch-board off before connecting power cable.
Power input +
Power input -
NC
NC
NC
To [POWER] connector
White
Black
Red
Green
Gray
External monitor connection
1 2 3 4 5
6 7 8
9
10
11 12 13 14 15
1 : R
2 : G
3 : B
4 : NC
5 : GND
6 : R-GND
7 : G-GND
8 : B-GND
9 : NC
10 : NC
11 : NC
12 : NC
13 : H-SYNC
14 : V-SYNC
15 : NC
Operation unit connection
1 : Shield
2 :+12V
3 : GND
4 : D+
5 : GND
6 : D-
7 : PSW1
8 : PSW2
6
5
4 3
2
1
7
8