Kodak MULTILOADER 700 PLUS, Installation Instructions Manual

Page: 80 / 96

NOTE
The SCREWS and ANCHORS for attaching the panels to the wall depend on the wall type.
SCREWS and ANCHORS are, therefore, not supplied. Get them locally.
The KODAK Multiloader 700 Plus Side-by-Side Darkroom Kit is installed from the lightroom.
Unpack it there.
The sides on which the LONG SIDE PANEL and the PROCESSOR PANEL are installed
depend on the positions of the PROCESSOR and the KODAK Multiloader 700 Plus.
The figures shown in this chapter are based on an installation of the PROCESSOR at the left side
and the KODAK Multiloader 700 Plus at the right side.
If your PROCESSOR is installed at the right side, just exchange the positions of the LONG SIDE PANEL
and the SHORT SIDE PANEL, and put the PROCESSOR PANEL to the right side.
GENERAL
For installation of the SBS, refer to the corresponding chapters. This chapter only describes
the additional steps necessary for the DARKROOM KIT.
Some parts of the DARKROOM KIT are finished only at one side. On installation, ensure that
the finished sides are visible.
II 3066-2
10/98 14-4 KODAK AG, Stuttgart