4. DARK ROOM FEED TRAY
1
.
Mount the 2 DFT SUPPORT BRACKETS to the rear of the SBS. Select the
PROCESSOR side. To mount the SUPPORT BRACKETS use 4 SCREWS M4X10. This
could be left or right, depending on the orientation of the system.
2
Route the wires of the RED/GREEN LED BOX through the DFT opening. Connect the
wires to the FLAT 3 PIN CONNECTOR at the inner side of the SBS REAR WALL.
NOTE
Fix the LED BOX preliminarlly with tape to the SBS to prevent the wires from breaking.
3
.
Place the DFT FEED SHELF onto the SUPPORT BRACKETS, route the DFT
SENSOR HARNESS into the SBS and connect it to the FLAT 2 PIN CONNECTOR at
the inner side of the SBS REAR WALL.
4
.
Mount the FEED TRAY to the SUPPORT BRACKETS with 2 SCREWS M5x12. Push
it fully against the SBS and then fasten the SCREWS. Ensure that the DFT SOLENOID
WIRES are inside the SBS.
5
.
Connect the DFT SOLENOID CONNECTOR to the round CONNECTOR at the rear
side of the SBS REAR WALL.
6
.
Place the DFT TOP COVER onto the FEED TRAY. Mount it with 4 COUNTERSUNK
SCREWS M4x20 to the rear of the SBS.
Mount the DFT SUPPORT BRACKETS to the
PROCESSOR side
figure 4-1
II 3066-2
KODAK AG, Stuttgart
4-1
10/98
Summary of Contents for MULTILOADER 700 PLUS
