4
.
Insert the PLASTIC BEARING into the BRACKET. Use the right-hand hole.
5
.
Feed the MAIN SWITCH EXTENSION from underneath through the PLASTIC
BEARING.
6
.
Screw the KNOB onto the MAIN SWITCH EXTENSION.
7
.
Slide the ACTUATOR on the short arm of the MAIN SWITCH EXTENSION.
8
.
Secure the ACTUATOR with 1 C-RING at the indicated C-RING POSITION, that it
cannot slide off.
9
.
Engage the ACTUATOR with the horizontal part of the PROCESSOR MAIN SWITCH.
10.
Gently pull up the KNOB to test if the MAIN SWITCH is actuated.
11.
Gently press down the KNOB to switch off the PROCESSOR MAIN SWITCH.
5000 RA PROCESSOR
PROCESSOR REMOTE ON/OFF
There is no PROCESSOR REMOTE ON/OFF!
PROCESSOR SET-UP 5000RA
CAUTION
CHECK THAT THERE IS REALLY 120 VAC AT THE SAFE LIGHT RECEPTACLE.
The SAFE LIGHT RECEPTACLE must provide 120 VAC as long as the PROCESSOR is
switched on. This can be selected via the PROCESSOR OPERATOR KEYBOARD.
The 5000RA CONTROL PANEL/DISPLAY should be actuated as shown in the FLOW CHART
on the next page in order to be certain that the “ACCESSORY MODE” is used.
NOTE
Press the highlighted buttons only!
II 3066-2
10/98
7-14
KODAK AG, Stuttgart
Summary of Contents for MULTILOADER 700 PLUS
