Electric motors Size 63 - 225 ATEX / IECEx
Faults
2021-05-31
43
Pos : 8. 2 / KN2006- SM/Stör ung en/001 1 Stör ung en_Tit el+Text @ 9\ mod_1144439647801_1.doc @ 86957
8 Faults
The following chapter describes possible causes of faults and the
work to eradicate them.
In case of faults which occur several times, reduce the
maintenance interval accordingly to suit the actual strain.
In case of faults which cannot be cleared using the following
instructions, contact the manufacturer, see service address on
page 2.
Pos : 8. 3 / KN2006- SM/Stör ung en/002 1.1 Sic herheit _Titel @ 9\ mod_1144439648502_1. doc @ 86964
8.1 Safety
Pos: 8.4 /KN2006-Projekte/Herforder Elektromotoren-Werke/Störungen/003 1.1.0 Personal @ 64\mod_1206009264903_1.doc @ 1073732
Staff
◼
Some tasks can only be carried out by specialist staff with
special qualifications or exclusively by the manufacturer. The
description of the respective individual fault makes reference to
this in each case.
◼
Work on the electrical equipment must only be carried out by
qualified electricians.
Pos : 8. 5 / KN2006- SM/ nL---------- Abschnit tsende ---------- @ 8\ mod_1141997892953_0. doc @ 75471
Pos : 8. 6 / KN2006- Proj ekt e/H erfor der El ektromot oren- Wer ke/ St örungen/ 003 1. 1. 0 Pers önlic he Schutz ausrüs tung @ 54 \ mod_1196342589631_1. doc @ 833025
Personal safety equipment and
clothing
Wear the following safety equipment and clothing for all faults
work:
◼
Occupational safety clothing
◼
Safety shoes
Pos : 8. 7 / KN2006- SM/ nL---------- Abschnit tsende ---------- @ 8\ mod_1141997892953_0. doc @ 75471
Pos : 8. 8 / KN2006- Proj ekt e/H erfor der El ektromot oren- Wer ke/ St örungen/ ATEX/ 003 1. 1. 0 Arbeit en zur St örungsbes eitigung EX-SCHUTZ @ 60\ mod_1203499429928_1.doc @ 1039989
Explosion protection
EXPLOSION PROTECTION!
The introduction of ignition sources such as sparks,
open flames and hot surfaces can cause
explosions in the potentially explosive area.
Therefore, when carrying out all work to remedy
faults in the potentially explosive area:
– Do not start any work without a written permit.
– Only carry out work to remedy faults to the
exclusion of a potentially explosive atmosphere.
– Only use tools which are approved for use in
the potentially explosive area.
Failure to adhere to these instructions will lead to a
loss of the explosion protection.
Pos : 8.9 /KN2006- SM/nL---------- Abschnittsende ---------- @ 8\mod_1141997892953_0.doc @ 75471
