23
Switching Output and Inputs on the SCE:
Move the mouse cursor pointer to the area of the Output/Input, when it’s over the
hot spot it will change to the hand symbol. Click with the mouse to activate the
Output/Input.
The reaction of an Output or Input on an SCE will vary but in general:
•
An Output can be switched on or off by clicking on the hot spot on the SCE.
•
A Motor output can be
a. Switched from 100% forward to 100% reverse by using the motor controls.
•
If no interface is connected then an Input
a. Maybe switched on or off by clicking on the hot spot on the SCE.
The SCE will duplicate the way a switch should react e.g.
• The bridge has proximity switches so it will be on when the bridge is open and off when the
bridge is closed (Bascole Bridge SCE).
• Push-button switches so will only stay on momentarily.
Note: If this type of switch is switched on from the I/O panel it will stay on until deselected
•
If the interface is connected then the control of an Input on an SCE is ‘taken over’ by the inputs
connected to the Control interface.
The screen layout
back to Table of Contents
