45
Using Learn
The simplest way to create a flowchart or procedure is to make use of the ‘Learn’ feature.
With Learn selected each time an output or motor is switched On or Off a command will
appear in the edit area with a wait command to record the time between each switch On
or Off.
•
Click on the Start Learn icon.
•
Click on the relevant outputs in the I/O panel or SCE to switch them on or off. The
Switch Output: command will automatically appear in the edit area. The time between
each selection will automatically appear as a wait command.
•
To stop the learn process click on the Stop Learn icon, a stop command will
automatically be entered at the end of the flowchart.
Note: Wait times will be rounded up to the nearest whole number when the software is set at Level 1,
or to one decimal place at Level 2.
The Flowchart created maybe edited or run in the same way as any other flowchart.
back to Table of Contents
