klover K top, User Manual

Page: 42 / 64

42
Switching on
Perform the following operations:

Before switching the heating cooker/heating stove on,
make sure that the control unit switch is on;

Make sure that there is water in the system and
reservoir;

Set the thermostat that controls the pump to a temperature
of 55-60 °C; NEVER set the temperature to lower than
55 °C because condensation could form in the boiler,
which in time could ruin the heating cooker/heating
stove;

Fully open the internal smoke damper turning the handle
on the hob fully anti-clockwise (heating cooker only
–
see
page 21 );

Fully open the internal smoke damper on the flue pipe inlet
by placing the handle in a vertical position (see page 21) ;

Slightly extract the ash drawer (by 3-4 cm) and open the
slots on it;

Light the fire using seasoned, thin wood;

When the wood has ignited well, close the ash drawer and
adjust the combustion air inflow using the front slots;

Close the internal smoke damper by turning the handle on
the hob fully clockwise to increase the efficiency of the
heating cooker and to provide more heat to the oven
(heating cooker only). If necessary adjust the draught in the
flue pipe by adjusting the smoke damper on the flue pipe
inlet.
THE FURNACE MUST BE KEPT CLOSED AT ALL TIMES
EXCEPT DURING REFUELLING IN ORDER TO PREVENT
THE ESCAPE OF SMOKE.
NEVER IGNITE THE HEATING COOKER/HEATING STOVE
USING ALCOHOL OR OTHER HIGHLY FLAMMABLE
LIQUIDS.
Always remember to open the smoke damper a few seconds
before loading the heating cooker/heating stove with new
wood in order to prevent the backflow of smoke into the room.