60
USEFUL ADVICE
1. The temperature of the thermostat that controls the pump
must
never
, for any reason,
be set below 55°C
, to prevent the formation
of condensate that could corrode the internal boiler.
2. To
give priority to DHW ( KP top/TSP top models only), set “
DHW
mode”
(see page 32)
and burn thin pieces of dry wood in order to
increase the flame. After use of the DHW, lower the thermostat to
55-60 °C.
3. Open the smoke dampers completely before loading the wood.
4. When necessary, "move" the wood using the fire hook supplied or
by adjusting the grille raising lever (heating cooker only) in order to
revive the flame.
5. To provide some humidity in the room where the heating
cooker/heating stove is installed, just place a pan filled with water
on the cast iron hob.
6.
Never empty
water into the heating cooker/heating stove so as not
to compromise its operating life.
THE MANUFACTURER ACCEPTS NO LIABILITY FOR PROBLEMS
DERIVING FROM THE FAILURE TO APPLY THE STANDARDS
CONTAINED IN THIS MANUAL.
Summary of Contents for K top
