GB
34
Installation Introduction
Please read these instructions COMPLETELY AND CAREFULLY. They will save you time and
effort and help to ensure optimum oven performance. Be sure to observe all WARNINGS.
These installation instructions are intended for use by a qualified installer. In addition to these
instructions the oven must be installed in compliance with the current Australian Standard.
Tools You Will Need
The following tools are needed to install your new oven:
• Tape measure and straightedge or ruler
• Pencil
• Phillips screwdriver
• Level
• Wire cutters and wire stripper
• 1” hole saw
• Hand or saber saw.
Power Requirements
The oven must be supplied with the proper voltage and frequency. The oven is manufactured to
be connected to a three wire single phase 230-240 VAC 50/60 Hz electrical supply. The oven
must be supplied with copper wires ONLY. A qualified electrician must perform the electrical
wiring and hook-up of your oven. After installation is complete have the electrician show you
where the main disconnection is and which of the circuit breakers/fuses are for the oven.
Choosing Oven Location
Carefully select the location where the oven will be placed. The oven should be located for
convenient use in the kitchen but away from strong drafts. Strong drafts may be caused by open
doors or windows or by heating and/or air conditioning vents or fans. Make sure that electrical
power can be provided to the location selected.
