GB
37
Electrical Supply
Before installing the oven have a qualified electrician verify that your home is provided with
adequate electrical service and that the addition of the oven will not overload the circuit on
which it is to be installed A separate three-wire single phase 230-240 V 50/60 Hz circuit is
required If the supply cord is damaged.
it must be replaced by the manufacturer its service agent or similarly qualified persons in order
to avoid a hazard
!!WARNING!!
ELECTRICAL SHOCK HAZARD
• The electrical power to the oven circuit must be shut off while line connections
are being made
• Do not use an extension cord with this appliance
• Electrical ground is required on this appliance
The free end of the yellow/green wire (the ground wire) must be connected to a
suitable ground This wire must remain grounded to the oven
• A qualified electrician must install the appliance
• The oven must be earthed in accordance with the current Australian Standard
NOTE: This appliance must be correctly installed and serviced by a suitably
qualified person, strictly in accordance with AS/NZS 3000 wiring rules.
• The oven must be connected to the mains through a multipole circuit breaker
with a contact-to-contact gap of a least 3 mm marking sure that the earth wire is
not disconnected.
Failure to follow these instructions could result in serious injury or death
Wiring Requirements
Before making connections make sure the power is off and read and observe the following:
• A separate three-wire single phase 230-240V 50/60 Hz circuit is required for the oven
• The oven must be connected with COPPER WIRE ONLY.
• The oven must be installed to conform with the current Australian Standard.
• Wire size (COPPER WIRE ONLY) and connections must be suitable for the rating of the
appliance per the current Australian Standard.
Connecting The Oven To The Mains
For connecting use a flexible rubber cable of the H05V2V2-F type (3x2 5 mm
2
min)
remembering to make it long enough to allow the oven to be removed from its housing unit
when maintenance work is required To connect the cable to the oven proceed as follows (see
fig 12):
