Kipp & Zonen RaZON+, Instruction Manual

Page: 40 / 72

40
3.16.8 Operating System
This shows a list with system information, hardware and software revisions and serial number. This information is good to have at
hand when communicating about the RaZON
+
with our local distributor or Kipp & Zonen offices.
3.16.9 Contact
On this page our Kipp & Zonen offices locations and contact details are listed.
3.17 Securing the tripod
After the RaZON
+
is levelled and aligned, it’s time to fix the tripod feet to its base.
During the fixation of the RaZON
+
’s mounting bolts it is recommended to check the levelling.
When the tension of the 3 legs or bolts is different a slight distortion of the levelling might occur.
Applying the right (same) amount of force on the 3 bolts will solve this.
3.18 Cable routing
When all communication, sensor and power cables are connected, the cable routing should be created correctly.
- Disconnect the power
- Combine all outgoing cables together on the cable clamp on the bottom of the RaZON
+
- Strap them with a tie-rap together (outgoing side facing down)
- Rotate the RaZON
+
to its home position, this is the middle of the maximum clock-wise and counter clock-wise position.
- For the tripod create a loop and tie this down to the middle of the nearest horizontal bar of the tripod. The length of the loop
between the 2 connection points is ~45 cm.
- For the pole mount secure the end of the loop to one of the nearest screws on to bottom of the pole mount.