Kipp & Zonen RaZON+, Instruction Manual

Page: 20 / 72

20
a
b
c
M4 x10mm flat head screw (3x)
Plastic washers (3x)
d
30
°
60
°
90°
90
°
90°
East
4 x 11,5 mm diameter holes for 4x M10 bolt
184.2
M8 x20 mm flat head screws (4x)
M4 x10mm flat head screw (6x)
Insulation rings (6x)
Tip
3.6 Mounting the Pole Mount
The pole mount can be used to install the RaZON
+
on a small surface like an extension tube or pole. The bottom flange of the pole
mount has 4 holes for M10 bolts to secure it to the pole or tube.
It is advised to mount all pole mount screws while the RaZON
+
is still in its box. While the RaZON
+
bottom flange is facing up, it is easier
to mount the pole mount this way.
The levelling is done with the 3 (tilt) screws in the top plate of the pole mount. Once properly mounted the 3 bolts connecting it to the
RaZON
+
can be fastened. This should be done after the complete installation of the RaZON
+
is ready. Always check the levelling
afterwards.
Please follow the next steps to mount the pole mount to your RaZON
+
Step 1: Fit the bottom flange (a) to the pillar (b) with the 4 supplied screws
Step 2: Fit the top flange (c) to the pillar with the 6 supplied screws and washers
Step 3: Secure the top plate to the bottom flange of the RaZON
+
with 3 screws (d) but only loosely as the RaZON
+
still needs to be
turned and levelled a bit later on.