Kipp & Zonen RaZON+, Instruction Manual

Page: 15 / 72

15
This chapter explains the installation of the RaZON
+
including the connection of the power cable. The installation is explained step by
step in the following paragraphs. Once the mechanical mounting is finished and power is connected the fine tuning and final check
can be done via Ethernet or Wi-Fi with a PC, tablet or smartphone.
• Required tools for RaZON
+
mounting
• Site preparations
• Mounting and operating area
• Connecting the tripod stand
• Connecting the pole mount
• Tracker orientation
• Pyrheliometer mounting
• Pyrheliometer mounting
• Shading Assembly mounting
• Levelling
• Connecting DC Power cable
• Set-up using Ethernet or optional Smart Wi-Fi device
• Securing the tripod
• Cable routing
Apart from the creation of the tripod support base, the levelling and the fine adjustment is only a matter of minutes. However a clear
sun is required to do this. It is important that the above steps are carried out in this order.
3.1 Safety Precautions
Many hazards are associated with installing and maintaining instruments on towers or elevated structures. It is advised to use
qualified personnel for installation and maintenance. The client is responsible for following the local safety regulations. The use of
appropriate equipment and safety practices is mandatory. Check your company's safety procedure and protective equipment prior
to performing any work. If the RaZON
+
is mounted at a high position, special care must be taken to secure both the person installing
it and the instrument from falling during installation.
While every attempt is made to get the highest degree of safety in our products, the client assumes all risk from injuries resulting from
improper installation, use or maintenance of the RaZON
+
.
3.2 Required tools for RaZON
+
For installation on site the following tools are required for mounting the RaZON
+
.
for Pyrheliometer mounting (PH1 comes pre-mounted): 5 mm Allen key
for Pyranometer mounting (PR1 comes pre-mounted): 3 mm Allen key
Shading arm: 2.5 mm Allen key, 5.5 mm wrench and Phillips screwdriver
Tripod: 3 mm Allen key and 3.5 mm Allen key (for adjustable feet)
Pole Mount: 3 mm Allen key (upper flange) and 6 mm Allen key (lower flange)
Shading assembly: 2.5 mm Allen key, Phillips screwdriver and 5.5 mm wrench
3. Installation