Kipor Sinemaster IG2000i, Operation Manual, Page: 76 / 90

20
after this system fault code is shown, the receptacle output may remain unchanged.
Beside, the remote operation gets well after system fault automatic cleaning. If the
system fault code can not automatically clean or the displayer shows other fault code,
please contact with Kipor dealer.
Figure 24
Meanings of fault codes
E-01 Engine under-speed protection
E-02 Engine over-speed protection
E-03 Inverter over-current protection
E-04 Inverter AC output over-voltage protection
E-05 Inverter over-heating protection
E-06 Inverter instantaneous over-current protection
E-07 Inverter DC component over-voltage protection
E-08 Inverter DC high voltage over-voltage protection
E-09 Inverter DC high voltage under-voltage protection
E-10 Communication error
E-99 02 sensor wire disconnected
5.3 Reset button
When overload indicator lamp lights, the generator will stop power output. At this time,
disconnect the load, check the load and the connection wire, after the failure resolved,
the user can press reset button in generator running status to extinguish the indicator
lamp. Let the generator continue to run and open the load again.
The red lamp and the green lamp may light at the same
time during the generator starting. It is normal If the red
lamp extinguishes in 4s. Otherwise, contact Kipor dealer.