Kipor Sinemaster IG2000i, Operation Manual

Page: 6 / 90

5
■
Always make a pre-operation inspection before you start the engine. You may
prevent an accident or equipment damage.
■
Place the generator at least three feet or one meter away from buildings or other
equipment during operation.
■
Operate the generator on a level surface to prevent fuel spillage or oil starvation.
■
Know how to stop the generator quickly and understand operation of all controls.
Never permit anyone to operate the generator without proper instructions.
■
Keep children and pets away from the generator when it is in operation.
■
Keep away from rotating parts while the generator is running.
■
The generator is a potential source of electrical shock when misused; do not
operate with wet hands.
■
Do not operate the generator in rain or snow and do not let it get wet.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.