Kilsen KFP-CE4 Series, Installation Manual

Page: 48 / 92

Chapter 3: Configuration and commissioning
42 KFP-CE4 Series Installation Manual
Display Description
Mixed zone. The control panel automatically
distinguishes between an automatic alarm (generated by
a detector) and a manual alarm (generated by a manual
call point fitted with a 100 Ω resistor). [1]
Automatic zone. All fire alarms are treated as reported
by a detector , even if the fire alarm is reported by a
manual call point in the zone.
Manual zone. All fire alarms are treated as reported by a
manual call point, even if the fire alarm is reported by a
detector in the zone.
[1] This option is not available if EN 54-13 is enabled or an intrinsically-safe
zone is configured.
Input configuration
Use this menu to configure the functionality of INPUT1 and INPUT2. The default
setting for each input is included in Appendix A “ Configuration presets” on page
71.
To configure an input:
1. Set the display as shown below, and then press Enter.
2. Select the i nput (for example, INPUT1), and then press Enter.
3. Select a value using the value selection buttons (2 and 4).
4. Press Enter.
5. Save your changes.
The available settings for this feature are shown below.
Display Description
Remote reset.
Input activation (transition) commands reset.
Delays off
Input activation (transition) deactivates delays
(equivalent to night mode).
Input deactivation (transition) activates delays
(equivalent to day mode).
Extended fire routing delay
Input active configures extended fire routing delay.