Kilsen KFP-CE4 Series, Installation Manual

Page: 33 / 92

Chapter 3: Configuration and commissioning
KFP-CE4 Series Installation Manual 27
User level passwords and indications
The default user level passwords and the corresponding LED and seven -
segment display indications are shown in the table below. The seven-segment
display is only visible when the control panel cover is removed. See Figure 1 on
page 6 .
Table 15: User level passwords and indications
User level
Password LED Default display Custom display
Public None None None None
Operator 2222 The Reset LED i s
steady
None None
Basic installer 3333 The Reset LED is
flashing
Advanced
installer
4444 The Reset LED is
flashing
Note: If you have used advanced configuration options to set a custom input
configuration, zone delay, zone configuration, or zone type, then the seven -
segment display defaults to the custom display operating mode. See “ Panel
mode” on page 33 for details.
Configuration overview
To facilitate rapid configuration of the most common tasks, configuration is
divided into basic and advanced levels.
For basic configuration options, see “ Basic configuration” on page 30. For
a dvanced configuration options see “ Advanced configuration” on page 36 .
Note: The reset and panel silence functions are not available in configuration
mode. To reset the control panel or sile nce the internal buzzer, first exit
configuration mode. See “ Common configuration tasks” on page 29 for
instructions on exiting from configuration mode.
Configuration controls
The control panel is configured using the front panel configuration controls and
the seven-segment display. The configuration controls are also used to enter the
user level password.
The configuration controls
The configuration controls are located on the control panel interface.