Kilsen KFP-CE4 Series, Installation Manual

Page: 46 / 92

Chapter 3: Configuration and commissioning
40 KFP-CE4 Series Installation Manual
Display Description
Passive end-of-line
Active end-of-line [1]
Passive end-of-line with CleanMe [1][2]
Active end-of-line with CleanMe [1][2]
Intrinsically- safe z one [1][3]
[1] Option not available if EN 54-13 supervision is enabled.
[2] The CleanMe feature is not available for Kilsen devices.
[3
] By default, even zones are configured as manual and odd zones are set
as automatic.
Zone delay
U se this menu to configure zone delays (on or off), for each zone in your fire
alarm and evacuation system. If the zone delay is ON, for alarms reported from
this zone, any output activation (fire routing and expansion board outputs) will
consider delay bef ore activation. The default setting for all zones is ON.
For a stand-alone control panel, you specify the zone using the zone number.
When the control panel is in a fire network, unique zone numbers are created by
defining a unique starting number for the first zone in each panel. For example, if
the first zone is numbered 101, then zone 0 4 will have the number 104.
In a fire network, if the control panel is configured to activate with remote zones,
you can enter “others” to select the delay for remote zone s.
See the topic “ Fire network and repeaters configuration” on page 48 for further
details.
To configure the zone delay:
1. Set the display as shown below, and then press E nter.
2. Select the zone (for example, zone 1), and then press Enter.
— or —