PLZ-4WH
65
4
Sequenc
es
Editing Programs in a Normal Sequence
To configure a program, select one of four operation modes (CC, CR, CV, or CP). You can
execute the same program repeatedly. You can also continue program execution by linking a
program to another program. Linked programs can only be executed if they have the same
operation mode and range. You can save up to 10 programs (No.1 to 10).
Press EDIT (SHIFT+A) to display a screen for configuring the programs in the sequence.
In the top screen, if you press
when the cursor is at Loop, the bottom screen appears. In
the bottom screen, if you press
when the cursor is at Last Load, the top screen appears.
In the screens for configuring the programs in the sequence, you can configure the following
items.
After you finish configuring the program settings, press NEXT (SHIFT+ ) to configure the
step settings.
Item
Setting
Description
No.
1 to 10
Program number (11 is for the fast sequence)
Memo
Up to 11 characters
A memo
Mode
NCC: CC mode
NCR: CR mode
NCV: CV mode
NCP: CP mode
The program operation mode
Range
8.25 A, 650 V (example)
The current and voltage ranges for the program
vary depending on the model.
Loop
1 to 9 998
9999: Infinite repetition
The number of times that the program will repeat.
Last Load
OFF: Load off
ON: Load on
The state of the load (on or off) after the sequence
finishes.
Last Set
0 to 100 % of the range
The fundamental setting at the end of the
sequence.
This setting is valid when Chain is set to OFF.
Chain
OFF: The sequence ends
1 to 10
Specifies the program that will be executed next.
Only programs with the same operation mode and
range can be executed.
SEQ
PREV
NEXT
No. :
1
Memo : Pro
g
ram1
Mode : NCC
Loop : 0001
Ran
g
e : 8.25A, 650V
SEQ
PREV
NEXT
Last Load : ON
Last Set : 0.0000
A
Chain :
2
Top
Bottom
