Kikusui KJM6335, Operation Manual, Page: 49 / 129

KJM6335 Operation 3-15
If the condition immediately before pressing the MEMORY
RECALL/STORE key is a state where the panel settings have been
changed (the LED at the left of the key is unlit), pressing the
MEMORY RECALL/STORE key causes the contents of the setup
memory address recalled before the panel settings were changed to
be recalled again.
Changing the panel settings after recalling the setup memory
contents causes the LED at the left of the key to go off.
• Select & recall
In this method, select the setup memory address you wish to recall
using the MEMORY SELECT key and then press the MEMORY
RECALL/STORE key to recall the contents of that setup memory
address.
When you press the MEMORY SELECT key, one of LEDs "1" to
"4", indicating the setup memory address on the left of the key,
blinks. Each time you press the key, the setup memory address
changes to 1, 2, 3, and 4 in sequence; select the setup memory
address you wish to recall.
Press the MEMORY RECALL/STORE key to recall the contents
of the selected setup memory address.
The selection state (condition in which the LED is blinking) will be
automatically cancelled unless you accept a recall action within 3
seconds, and will return to the status that existed before the
MEMORY SELECT key was pressed. Moreover, if you change
the panel settings in the selection state, the LED goes off.
SHIFT
LOCAL
RMT
STORE
RECALL
1 2 3 4
GPIB
MEMORY
SELECT
MEMORY SELECT key
MEMORY RECALL/
STORE key
Fig. 3-6