Kikusui IB022853, User Manual

Page: 8 / 52

8
Installation and Preparation KPM1000
1
Installation and Preparation
This chapter describes how to unpack and prepare this product before you use it.
Connecting the power cord
Check whether the AC power line is compatible with the input rating of the product. The
product can receive a nominal line voltage in the range of 100 VAC to 240 VAC at 50 Hz or
60 Hz.
1
Check that the POWER switch is turned off ( ).
2
Connect the power cord to the AC INPUT inlet on the rear panel.
3
Connect the power cord plug to a properly grounded outlet.
4
In case that the measurement exceeds 7 A (rms), securely connect a
cable to the
(protective conductor terminal) for earth ground on the
rear panel. Use a cable which maximum current rating is above the
current to measure.
WARNING
Possible electric shock.
This product is a piece of equipment that conforms to IEC Safety Class I (equipment
that has a protective conductor terminal). Be sure to earth ground the product to
prevent electric shock. Connect the ground terminal to earth ground.
• Use the supplied power cord to connect to the AC line.
If the supplied power cord cannot be used because the rated voltage or the plug shape is
incompatible, have a qualified engineer replace the power cord with an appropriate power
cord that is 3 m or less in length. If obtaining a power cord is difficult, contact your Kikusui
agent or distributor.
• The power cord with a plug can be used to disconnect the product from the AC line in an
emergency. Connect the plug to an easily accessible power outlet so that the plug can be
removed from the outlet at any time. Be sure to provide adequate clearance around the
power outlet.
• Do not use the supplied power cord as the power cord for other devices.