Kikusui IB022853, User Manual

Page: 17 / 52

KPM1000 Installation and Preparation
17
Turning the POWER switch on
Turning the POWER switch on
Flip the POWER switch to the ( ) side to turn the KPM1000 on. The firmware version is
displayed for approximately 1 second (display A shows “VEr” and display C shows the
number), and then the KPM1000 starts in measurement mode. If you notice strange sounds,
unusual odors, fire, or smoke around or from inside the KPM1000, turn the KPM1000 off.
Factory default
settingsp.50
The first time that you turn the KPM1000 on, it starts with the factory default settings. You can
use these settings to start performing basic measurements. The following times that you turn
the KPM1000 on, it will start with the settings that were in use immediately before it was last
turned off.
p.19
The KPM1000’s screen shows displays A, B, C, and D, and the status indicators. Displays A,
B, C, and D show measured values. Use the DSPL keys to select the display items. The four
displays are divided into two groups: (1) displays A and C and (2) displays B and D. The
same types of display items are shown within each group. The status indicators show the
operating status of the KPM1000.
Turning the POWER switch off
Flip the POWER switch to the ( ) side to turn the KPM1000 off.
See
See
Display
A C
Display
B D
Status indicators
You can select the same display item
for displays A and C.
You can select the same display item
for displays B and D.