Kikusui IB022853, User Manual

Page: 30 / 52

30
Basic Operations KPM1000
Configuration settings
Interface menu contents
In the following table, the underlined options are the factory default settings.
ConF.9 intEG on/oFF • This turns the integration timer on and off.
• When you select “on,” integration continues until the time
specified by ConF.10 elapses.
• When you select “oFF,” integration continues until you
stop it manually (or until 9999 hours and 59 minutes
elapses).
ConF.10 intEG.t 0.0 to 9999.59
(the factory
default setting is
0.01) • This sets the integration time. Set the time using the
following format: hours.minutes.
Display
Description
Number
(DSPL C)
Item
(DSPL B)
Option (DSPL D)
Display
Description
Number
(DSPL C)
Item
(DSPL B)
Option (DSPL D)
iF.1 SELECt rS-232C/GPIb/
uSb • This selects the remote interface. The RS232C interface
is installed as standard. GPIb and uSb can only be
selected when the corresponding optional interface is
installed.
• The interface that is selected in the factory default
settings is the optional interface.
iF.2
(rS-232C) bit.P.SEC 2400/4800/ 9600/
19200/ 38400
• This sets the baud rate.
• You can only configure this setting when you set
SELECt to “rS-232C.”
iF.3
(rS-232C) FLo.Cont on/oFF • This turns the xon/xoff flow control on and off.
• You can only configure this setting when you set
SELECt to “rS-232C.”
iF.2
(GPIb) AddrESS 1 to 30
(steps of 1) • This sets the GPIB address.
• You can only configure this setting when you set
SELECt to “GPIb.”
iF.2
(USb) VEnd.id None • This displays the USB vendor ID.
• This is only displayed when you set SELECt to “USb.”
iF.3
(USb) Prod.id None • This displays the USB product ID.
• This is only displayed when you set SELECt to “USb.”
iF.4 Err.trAC on/oFF • This turns the error trace display on and off.
• When you turn the error trace display on, if a
communication error occurs, the error number is shown
on display D. Press
▼ to display the next error. When
the error queue is empty, the KPM1000 returns to the
normal display.