71
2 x Upper Post 31.8 x 82.6 x 1495.4mm
2 x Short Post 31.8 x 82.6 x 933.6mm
2 x Roof Side 15.9 x 82.6 x 1019.2mm
1 x Side Top 15.9 x 82.6 x 784.2mm
1 x Tunnel Side Top 15.9 x 82.6 x 784.2mm
6023
6029
6030
6012
6000
Wood Parts
Hardware
Step 28: Upper Frame Assembly
Adventure Tower Assembly
A:
Place 1 (6012) Short Post and 1 (6000) Upper Post side by side with the (6012) Short Post on the left side making
sure that the notched out end is at the bottom and facing the outside. Place (6023) Roof Side at the top of the posts
so that it’s flush and attach using 2 (H2) ¼ x 2” Hex Bolts (with lock washer, flat washer and t-nuts).
(Fig. 28.1)
B:
Place (6029) Side Top so it lines up with the lower pre-drilled holes on the posts and attach using 2 (H2) ¼ x 2”
Hex Bolts (with lock washer, flat washer and t-nuts).
(Fig. 28.1)
C:
To make a second partial upper frame assembly place 1 (6012) Short Post and 1 (6000) Upper Post side by side
with the (6012) Short Post on the right side, notched side facing out and the (6000) Upper Post on the left side. Place
(6023) Roof Side at the top of the posts making sure it’s flush and attach using 2 (H2) 1/4x 2” Hex Bolts (with lock
washer, flat washer and t-nuts).
(Fig. 28.2)
D:
Place (6030) Tunnel Side Top so it lines up with the lower pre-drilled holes on the posts and attach using 2 (H2) ¼
x 2” Hex Bolts (with lock washer, flat washer and t-nuts).
(Fig. 28.2)
Set the upper assemblies aside, they will not be used until a later step.
H2
8 x
1/4 x 2” Hex Bolt (with 1/4” lock washer, 1/4” flat washer and 1/4” t-nut)
Fig. 28.2
6012
1/4”
t-nut
1/4”
t-nut
1/4”
t-nut
1/4”
t-nut
1/4” lock
washer
1/4” lock
washer
1/4” flat
washer
1/4” flat
washer
H2
X4
loosely assmble
6030
H2
6000
6023
2 angles shown, pick the best one
square each sub assembly
D
add 1/4" T-Nut to inside
of Long Post
Fig. 28.1
6012
6029
6023
6000
1/4” t-nut
1/4” lock
washer
1/4” lock
washer
1/4” flat
washer
1/4” flat
washer
H2
H2
2 angles shown, pick the best one
square each sub assembly
D
add 1/4" T-Nut to inside
of Long Post
2 angles shown, pick the best one
square each sub assembly
D
add 1/4" T-Nut to inside
of Long Post
