101
A:
Bend all 8 MOD Tunnel Panels as shown in fig. 52.1.
B:
Match 2 MOD Tunnel Panels together by making a slight “V” with the pieces so the peak of the “V” faces
away from you. Make sure connector tabs are coupled then straighten the 2 panels. Push down on one panel
and up on the other until you hear the connector tabs click together and the bottom edges are flush. You may
have to knock panels on a hard surface to align properly. Do this so there are 4 MOD Tunnel Panels attached
together. (fig. 52.2)
C:
Press nodules through the connector tab holes to hold Tunnel Panels in place. (fig. 52.2 and 52.3)
D:
Repeat Steps B-C to create two Tunnel Sides.
Step 52: Build Tunnel Assembly
Part 1
8 x MOD Tunnel Panel
Other Parts
Fig. 52.1
Fig. 52.2
Fig. 52.3
