110
A:
Place 2 (6015) Box Legs so that the cut outs are on the outside and at the bottom. Place 1 (6004) Box Bottom across the
top of the boards making sure that all top holes line up. Attach with 4 (H2) ¼ x 2” Hex Bolts (with flat washer, lock washer and
t-nut) making sure that the t-nuts are installed into the Box Bottom. (Fig.57.1 & 57.2)
B:
Fit 1 (6011) Box Side into the cut outs on each (6015) Box Leg and attach with 1 (H12) ¼ x 3” Hex Bolt (with flat washer,
lock washer and t-nut) per side. (Fig.57.1 & 57.2).
C
: From inside the frame place 1 (8832) Box End so that it’s pressed up flush to both (6015) Box Legs with the pre-sunk holes
at the bottom and towards the outside (Fig.57.3). Attach with 2 (H1) ¼ x 1-1/2” Hex Bolts (with flat washer, lock washer and
t-nut), 2 (S15) #8 x 1-3/4” Wood Screws and 2 (S4) #8 x 3” Wood Screws as shown in (Fig.57.1 & 57.2).
Step 57: Sand and Water Table Assembly
Part 1
Adventure Tower Assembly
Fig. 57.1
Fig. 57.2
Flush
6011
6004
8832
6015
H2
H12
H12
lock washer
lock washer
lock
washer
flat washer
flat washer
flat
washer
1/4”
t-nut
S15
S4
H1
H1
1/4”
t-nut
1/4” t-nut
Hardware
2 x
#8 x 3” Wood Screw
2 x
#8 x 1-3/4” Wood Screw
S4
S15
1 x
Box Bottom 23.8 x 82.6 x 409.6mm
2 x
Box Leg 23.8 x 82.6 x 444.5mm
2 x
Box Side 23.8 x 82.6 x 768.4mm
1 x
Box End 23.8 x 82.6 x 362mm
Wood Parts
6004
6015
6011
8832
2 x
¼ x 3” Hex Bolt (with flat washer, lock washer and t-nut)
2 x
¼ x 1-1/2” Hex Bolts (with flat washer, lock washer and t-nut)
4 x
¼ x 2” Hex Bolts (with flat washer, lock washer and t-nut)
H12
H1
H2
