Keysight U8030A Series, User Manual

Page: 54 / 66

Operation and Features 2
Keysight U8030A Series User’s Guide 53
4 Enable the OVP.
– Press the [Over Voltage] button again to end the adjustment and enable
the OVP.
– The display will show dOnE .
– The corresponding OVP annunciator ( OVP1 or OVP2 ) turns on.
Disable the OVP
1 Select an output channel with OVP enabled.
– Press [1] to select Output 1, or
– Press [2] to select Output 2.
– The corresponding annunciator ( OUT1 or OUT2 ) turns on.
2 Disable the OVP.
– Press the [Over Voltage] button again to disable the OVP.
– The corresponding OVP annunciator ( OVP1 or OVP2 ) turns off.
Clear the overvoltage condition
The OVP trip can only occur if the corresponding output is enabled. When the
OVP trip occurs, the corresponding output is disabled automatically.
– If the OVP trip occurs on Output 1, the display shows
triP on line 1 and the
OVP1 annunciator blinks.
– If the OVP trip occurs on Output 2, the display shows triP on line 2 and the
OVP2 annunciator blinks.
NOTE
To cancel this operation, allow the unit to idle for five seconds.