Keysight PD1000A, Startup Manual

Page: 43 / 108

Keysight PD1000A Power Device Measurement System Startup Guide 41
IV and CV Test Requirements IV and CV Device Characterization
Create the IV and CV and CV-IV Switching Setups in the Library
This section uses the UHC Selector Input Selection.xkd file that you downloaded
to a memory stick. See “Download Setup and Configuration Files” on page 19.
1 For the B1506A, insert the memory stick into the front panel.
2 In the tabs at the left, select Application Test.
3 Then select Library > Import.... Show All Files.
4 Locate and import the UHC Selector Input Selection.xtd file.
5 Click the UHC Selector Input Selection icon.
Setup the IV to CV Switch
1 Specify the HVSMU slot. (See Figure 15 above and refer to the Modules tab in
“Configure EasyEXPERT” on page 37. Typically, the HVSMU slot is Slot 7.)
2
For the SMU Slot Number, enter
0
(zero).
3
Click the
Save
tab (right side of screen) to save it to My Favorite.
4
Right click the icon and rename it as
IV to CV
. IMPORTANT: use this exact file
name as shown, including the spaces between words and capitalization.
Figure 15 Configure the IV to CV and CV to IV Switch Parameters