U3022AM42
Controlling the Test Set with N5242A/B
Figure
3
7
Command Console for 'B' Model Analyzers
SCPI Command Processor Console
There are two methods in which the PNA-X Command Processor Console can be used to
control the Test Set internal switches to configure the Multiport system for S-Parameter
measurements.
Method 1 - Using GPIB/SCPI Command Values
This method is available while the system is in Multiport mode only.
The Test Set internal switch settings are programmed into the Test
Set firmware; they are configured by the PNA-X S-parameter values.
Method 1 provides more PNA-X control capability than Method 2.
The following example shows two executable commands needed to
create an S-parameter measurement on your Multiport system.
Figure
3
8
Method 1 - Using GPIB/SCPI Command Values
Keysight U3022AM42 User's and Service Guide
43
