N5511A Phase Noise Test System User’s Guide 367
Preventive Maintenance
Instrument Installation
Instrument Installation
To install or re-install an instrument in a system, use one of the following
procedures.
Required Tools
— #2 Phillips screwdriver
— #2 POZIDRIV screwdriver
— system installation guide
Standard rack instrument
Table 19-6
To install an instrument
Step
Notes
1.
Slide the instrument gently into the
rack.
2.
Insert the screws in the rack ears.
Most cables are fairly easy to remove and
reconnect and have no special
considerations (besides making sure you
put the cables back in the right place).
Semirigid cables require more care,
especially when reconnecting them. Make
sure all semirigid cables, on the front and
back of an instrument are fully disconnected
before removing the unit.
3.
To reconnect the semirigid cables,
carefully align them before you insert
the male connector.
Do not insert the male pin in at an angle or
you will damage the female connector. RF
connector center pins are very delicate, and
if damaged must be replaced. System
performance may be greatly impaired if
there is a bad RF connector.
4.
Turn on system power and restart the
system computer if necessary.
Summary of Contents for N5511A
