188 N5511A Phase Noise Test System User’s Guide
Residual Measurement Examples
Amplifier Measurement Example - Single Channel
Amplifier Measurement Example - Single Channel
This example contains information about measuring the residual noise of
two-port devices. It demonstrates a residual phase noise measurement for an
Chapter 7, “Residual and Additive Noise Measurement
for more information about residual phase noise
measurements.
Required equipment
— RF amplifier
— Stimulus source (at frequency under test) - for this example, an E8257D
PSG will be used
— RF calibration source
— Coaxial cables and adapters necessary to connect the DUT and reference
source to the test set.
Connections
Setup the measurement using the following connection diagram.
Figure 8-1
Setup for Single Channel measurement
To prevent damage to the test system’s hardware components, verify that the input signal is
within the test system’s power limits. Refer to the N5511A Data Sheet online.
Summary of Contents for N5511A
