Key Automation TELESCOPIC LEVANTE, Instructions And Warnings For Installation And Use

Page: 75 / 156

75
EN
12.5 - Error code examples
Error Description
E00
No communication between function selector and equipment. The incorrect or absence of connection of the function
selector causes the appearance of the error E 00 on the display of the PRO selector and non-operation of the
equipment display
E101 Obstacle detected with closing current. The equipment continues normal operation.
E201 Obstacle detected due to encoder stopped during closure. The equipment continues normal operation.
E102 Obstacle detected with opening current. The equipment continues normal operation.
E202 Obstacle detected with encoder stopped in opening. The equipment continues normal operation.
E03 Faulty encoder. The equipment stops and will only attempt to resume operation after being reset or turned off.
E04 Power supply absent. The equipment continues operation, as set with parameter F.
E05 Low battery. The equipment normally continues operation as long as the battery voltage permits it.
E06
Learned stroke greater than the maximum permitted. The equipment will only attempt to resume operation after
being reset or turned off.
E07 Flat battery. The equipment stops.
E08
Motor polarity reversed or encoder channels reversed. The equipment stops and will only attempt to resume
operation after being reset or turned off.
E09
Weight detected higher than the max. permissible. The equipment will only attempt to resume operation after being
reset or turned off.
E10
Motor current greater than the maximum permissible detected.
The equipment will attempt to resume operation after a new command.
E11
Overload protection of the power circuit has occurred. The equipment will attempt to resume operation after a new
command.
E12
EEPROM memory read or write error The equipment will attempt to resume operation only after being reset or
turned off.
E13 Monitored device test 1 failed PHOTO command
E14 Monitored device test 2 failed PHOTO command
E15 Monitored device test 1 failed PHOTO RALL command
E16 Monitored device test 2 failed PHOTO RALL command
E17 Monitored device test 1 failed STOP command
E18 Monitored device test 2 failed STOP command
E19
Excessive temperature of the power electronics. The equipment will only attempt to resume operation after being
reset or turned off.
E20 Power electronics failure, The equipment will only attempt to resume operation after being reset or turned off.
ESC
MENU
OK
PROGRAM MENÙ
P5 P4
P1
P2
AS
P1
ESC OK
P2