Kerotest Manufacturing
–
SHANNON & PAF III OPERATORS MANUAL - REV 3
Page 37 of 60
Once the barcode has been successfully scanned, the fitting information will be shown on the display. It
could look something like this:
INNO 2
” COUPL
60 sec START?
This should be the same data that is displayed on the screen of the processor and is an indication that
the fusion is ready to be started. At this point in time the fusion can be started by pressing and holding
the
button
on
the SMART Scanner™ for
a few seconds. As the fusion is in progress, th
e SMART Scanner™
display will look something like this:
FUSION IN PROCESS
Press Button to STOP
At any time, you may press and hold the
button
to stop the fusion.
If errors are encountered during the fusion process,
the SMART Scanner™ will al
ert the operator by
showing the following message:
ERROR RECEIVED
Check Processor!
At this point, you should consult the display of the processor itself for the specific error code and take
appropriate corrective action based on the information displayed.
GPS Mode
Operating the SMART Scanner™ in GPS Mode is the same as operating the SMART
Scanner™ in Smart
Scan Mode with the addition of GPS data. For this reason, only the differences are highlighted in this
section.
When the
SMART Scanner™ prompts the
operator to connect the fitting, the current GPS position will be
displayed after the satellites have been acquired. The screen will look something like this:
CONNECT FITTING 8-1
39.65678N-75.77673W
The display shows the current latitude and longitude as well as the number of satellites that the SMART
Scanner™ is currently tracking and the Position Error Indicator. The SMART Scanner™ can only
accurately report the current position when it is tracking more than 5 satellites. The example above
shows that it is tracking 8 satellites, the level of signal confidence is 1 and the current position is
39.65678 degrees North latitude and 75.77673 degrees West longitude. In general, the higher the
number of satellites and the lower the Position Error Indicator Number, the better the position accuracy
will be.
