41
PBJ_N-SH-e-1810.docx
16.4 Replacing the Assy,I/F (B5)
-
Detach the Assy,Case (3) / Assy,Pan support (4) in accordance with the steps outlined in
“3. Inspection of the Balance Interior”.
-
Undo the CS-5 clip (B15) securing Cable,flat26 (B6).
-
Disconnect the Cable,flat26 (B6) connector from the Assy,I/F (B5).
-
Unscrew the two P4 M4x8 screws (B10) fixing the Assy,I/F (B5). Loosen the four
CDHWE101S00 screws (B9) securing the external key connector (15-pin connector) and
the RS-232C (D-Sub25 pin connector) to detach the Assy,I/F (B5) (Fig.9).
-
Fit the new Assy,I/F (B5) by following the steps 2) to 4) outlined above in reverse order.
16.5 Replacing the Switch board assy (C3)
-
Detach the Assy,Case (3) / Assy,Pan support (4) in accordance with the steps outlined in
“3. Inspection of the Balance Interior”.
-
Disconnect the Cable,L105 connector (14) from the Switch board assy (C3).
-
Loosen the five M3x6 screws (C7) and detach the Switch board assy (C3).
-
Detach the Spacer for switch (C2) from the Switch board assy (C3) (Fig.10).
Note: The Spacer for switch (C2), made of resin, is thin in certain parts. Handle with care
to avoid damaging it.
-
Fit the new Switch board assy (C3) by following the steps 2) to 4) outlined above in
reverse order.
C3
B6
C2
B9
Fig.9
Fig.10
Summary of Contents for PBJ-N
