67
PBJ_N-SH-e-
1810.docx
-
Press the
to go to the single digit
: The “0” of “40” will flash.
-
Press the
to select 1 (flashes)
: Register 41 is selected.
-
Press the
to provisionally set the data in register 41 : the contents of register 41
are displayed (the contents of the EEPROM will not be altered at this point).
-
Manipulate the
und
keys to change the data flashing currently to the desired
value. Press the
key after the change is established to save the data.
At the
same time, the storage register will move up one location, and the “4” of register
“42” will flash. By pressing the
key at this point you will enter the register 42
data edit mode. To alter the register, repeat steps (1) (2) (3) above, select the register
with step (4) and change the data with step (5). Repeat this as necessary.
-
To renew the EEPROM (non-volatile memory) data, press the
key down for
more than 3 seconds until “- - -“ is displayed. “SET” will appear after this and the data will
be renewed. To leave this section without renewing the data, press the
key. “Abort”
will be displayed and the EEPROM data will not be renewed.
-
How to initialize the EEPROM (performed only when “Err 00” or “Err 05” is shown)
(From “Err 00” or “Err 05” display) Keep pressing the left end of
and
key
simultaneously until “rESEt” is displayed. The EEPROM is then initialized.
Summary of Contents for PBJ-N
