Kenwood KRF-X9992D, Connection And Setup Manual

Page: 21 / 145

15
Chapter One : Connecting Your Devices Audio-Video Receiver KRF-X9992D
Connections
Connecting Your Primary CD Player, continued
Do not plug in the receiver to AC power until you
have connected all your devices.
This section focuses on the connections from your
200-Disc CD Changer to the KRF-X9992D. Please
refer to your changer’s instructions for more detail
about its connection jacks and capabilities.
Each set of instructions in this section shows one of
several possible variations on connecting your CD
player(s). For further assistance on optional configu-
rations, contact the store where you purchased your
CD player(s).
The illustration shows a Kenwood 200-Disc CD
Changer. Your CD player may look different.
Kenwood DPF-J9010 contains two CD transports.
You must connect it as though they were two CD
players.
What if I Have a Video CD-Compatible
CD Player?
Connect the audio and video cables from the CD
player to any unused Video jack set.
Do not connect the system control cable in this
instance.
To Connect a Kenwood 200-Disc CD
Changer:
1. Connect the audio cables from the 200-Disc
Changer to the receiver’s CD1 jacks.
If you have a Kenwood DPF-J9010, connect
Output A to the receiver’s CD1 jacks and Output
B to the receiver’s CD2/Tape2 Monitor PLAY IN
jacks as shown to the left.
2. Connect the optical digital cable from the
changer to the receiver’s CD1 OPTICAL jack as
shown to the left.
3. Connect the system control cable from the
changer to the SYSTEM CONTROL jack as shown
to the left.
Be sure that the SL16/XS8 switch on both the
changer and the receiver is set to SL16.
If you are connecting more than one Kenwood
device with a system control cable, see “What if I
Have Several Kenwood Devices (System Control
Chaining)?” on page␣ 30 for more information.
4. Connect the SL16 text cable (communication
cable) from the changer to the receiver’s SL16
TEXT jack as shown to the left.
5. Go to “Noting Your Devices” on page␣ 3 and note
which jacks you used to connect your CD
changer. In addition, note the brand name and
model number of the CD Changer.
To Connect Any Other Primary CD
Player or Changer:
1. Connect the audio cables from the CD player’s
audio jacks to the receiver’s CD1 jack set as
shown to the left.
2. Connect the optical digital cable from the CD
player’s digital jack to the receiver’s CD1 OPTI-
CAL jack as shown to the left.
3. If you are connecting a Kenwood CD Player with
system control, connect the system control cable
from the CD player to the system control jack as
shown to the left.
Be sure that the SL16/XS8 switch on both the
player/changer and the receiver is set appropri-
ately.
If you are connecting more than one Kenwood
device with a system control cable, see “What if I
Have Several Kenwood Devices (System Control
Chaining)?” on page␣ 30 for more information.
4. Go to “Noting Your Devices” on page␣ 3 and note
which jacks you used to connect your CD player/
changer. In addition, note the brand name and
model number of the CD player or changer.
To Connect a Secondary CD Player:
See “Connecting Your Secondary CD Player or Tape
Deck” on page␣ 22.