Kenwood KRF-X9992D, Connection And Setup Manual

Page: 131 / 145

72 Audio-Video Receiver KRF-X9992D
T
roubleshooting
Sound
Sound
I don’t hear any sound at all
Check that:
• The volume is set at the proper level. See “Adjusting the
Volume” on page␣ 10 of this manual.
• Mute is OFF. If the MUTE indicator on the front of the
receiver is blinking, MUTE is ON. See “Muting Sound” on
page␣ 15 of this manual.
• The proper input (e.g., CD player, Tuner, etc.) has been
selected on the PowerTouch. See “How Do I Operate De-
vices?” on page␣ 26 of this manual.
• The CD2/Tape2 monitor input has not been selected. (If it
has, the CD2/Tape2 monitor indicator on the receiver’s front
panel will be lit). See “What’s on the Front Panel of Your
Kenwood Audio - Video Receiver?” on page␣ 2 of this manual.
• The input mode matches the input signal (e.g., analog vs.
digital) that has been set. See “Switching to Analog Input” on
page␣ 21 of this manual.
• The correct Listen Mode (e.g., Auto) has been set for the
digital input. See “What are Listen Modes?” on page␣ 16.
• The correct speakers have been activated. See “Turning the
Speakers On” on page␣ 10 of this manual.
I can’t hear sound from one or more of the speakers, or
the sound is abnormally low
Check that:
• All of the speaker wires are connected tightly, not short
circuited. See Chapter One of the Connections and Setup Guide .
• All of the speakers have been activated in the Setup Speakers
menu. See Chapter Two of the Connections and Setup Guide .