Kenwood KRF-V9993D, Connection Manual

Page: 41 / 180

35
R
emote Setup
Chapter Two : Setting Up PowerTouch
a. Aim PowerTouch at the receiver. If the speaker is
present, touch the speaker button until “Yes” appears
in the button. (SW=subwoofer, C=center, LS=left sur-
round, and RS=right surround):
If you selected Yes for the subwoofer, all of the bass
below 80Hz is removed from other speakers in your
system and is sent to the subwoofer in all listening
modes. This improves your speakers’ power handling
and reduces overall distortion.
b. Touch to save your settings.
c. Touch to move to the next speaker setting or
touch to return to the Setup Surround menu.
Custom setup: Use this method for a more customized
setup where you determine more of the speaker settings,
such as the bandwidth of the sound sent to each speaker.
Custom setup configures the following: SW=subwoofer,
L=left front, R=right front, C=Center, LS=left surround,
and RS=right surround.
a. Touch on the Speaker Selection menu:
b. Aim PowerTouch at the receiver and touch the
speaker button until the correct setting appears (see
below).
The left and right front buttons and the left and right
surround buttons are linked; if you touch one, you
change the settings for both.
• Off means you are not using the speaker. (Not avail-
able for front speakers). If no subwoofer is connected,
all bass below 80Hz is sent to left and right front
speakers.
• On means that you are using the speaker. (Only avail-
able for subwoofer).
• Select Nml (= Normal) if the speaker is not capable
of producing clean, deep bass energy at output levels
that match those produced by a typical powered
subwoofer. All bass below 80Hz in that channel is
removed from that speaker and is sent to the sub-
woofer (or sent to the front speakers if subwoofer is
set to off) in all listening modes. Most speakers
should be considered
Nml . If no subwoofer is con-
nected, that signal is sent to left and right front speak-
ers.
• Select Lrg (= Large) if the speaker is capable of pro-
ducing clean, deep bass energy at output levels that
match those produced by a typical powered
subwoofer. All bass below 80Hz in that channel is
left in that speaker in all listening modes.
The subwoofer may not output audio depending on
the setups of the input signal, speakers and listen
mode.
To begin setting up speakers:
1. Touch (setup) on the Main menu to access the Setup
menu.
2. Touch on the Setup settings.
SP Selection
1. Touch on the Setup Surround menu to
open the Speaker Selection menu:
2. Kenwood provides two ways to set up your speakers:
Quick Setup: Use this method for a simplified setup
where you identify whether a speaker is present and let
the receiver automatically determine the appropriate
speaker settings.