Keithley SourceMeter 2600B Series, Reference Manual

Page: 599 / 897

Section 7: TSP command reference Series 2600B System SourceMeter® Instrument Reference Manual
7-260 2600BS-901-01 Rev. C / August 2016
Also see
bufferVar.clearcache() (on page 7-20)
Configuring and running sweeps (on page 3-29)
smuX.trigger.measure.action (on page 7-260)
smuX.trigger.measure.Y() (on page 7-264)
smuX.trigger.source.action (on page 7-266)
smuX.trigger.source.linearY() (on page 7-268)
smuX.trigger.source.listY() (on page 7-269)
smuX.trigger.source.logY() (on page 7-270)
Triggering (on page 3-32)
smuX.trigger.measure.action
This attribute controls measurement actions during a sweep.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes SMU reset
Instrument reset
Recall setup
Not saved 0 (smuX.DISABLE)
Usage
action = smu X .trigger.measure.action
smu X .trigger.measure.action = action
action
The sweep measurement action; set to one of the following values:
0 or smu X .DISABLE : Do not make measurements during the sweep
1 or smu
X
.ENABLE : Make measurements during the sweep
2
or
smu
X
.ASYNC
: Make measurements during the sweep, but asynchronously
with the source area of the trigger model
X
Source-measure unit (SMU) channel (for example,
smua.trigger.measure.action
applies to SMU channel A)
Details
With this attribute enabled (setting action to smu X .ENABLE or smu X .ASYNC ), configure the
measurement with one of the smu
X
.trigger.measure.
Y
() functions.
If this attribute is set to smu X .ASYNC :
• Asynchronous sweep measurements can only be used with measure autoranging turned off. To turn
measure autoranging off for all measurements during the sweep, set the
smu
X
.measure.autorange
Y attribute to
smu
X
.AUTORANGE_OFF
.
• Autozero must also be turned off. To turn off autozero, set the smu X .measure.autozero attribute to
smu
X
.AUTOZERO_OFF
or
smu
X
.AUTOZERO_ONCE
.
If either of the above items is incorrectly configured, the smu X .trigger.initiate() function
generates an error.
Also see
smuX.trigger.autoclear (on page 7-253)
smuX.trigger.measure.Y() (on page 7-264)
Triggering (on page 3-32)