Keithley SourceMeter 2600B Series, Reference Manual

Page: 590 / 897

Series 2600B System SourceMeter® Instrument Reference Manual Section 7: TSP command reference
2600BS-901-01 Rev. C / August 2016 7-251
Details
The SMU will automatically clear all the event detectors when the smu X .trigger.initiate()
function is executed. This function should be called after the sweep is initiated.
A common example of when this function can be used is when you want the SMU to immediately
perform an action the first time through the trigger model even if a programmed trigger event does not
occur.
This function can also be used to start actions on the SMU in case of a missed trigger event.
Example
smua.trigger.arm.set()
Sets the arm event detector to the
detected state for SMU channel A.
Also see
smuX.trigger.initiate() (on page 7-259)
smuX.trigger.measure.set() (on page 7-261)
smuX.trigger.source.set() (on page 7-271)
smuX.trigger.arm.stimulus
This attribute selects the event that will cause the arm event detector to enter the detected state.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes SMU reset
Instrument reset
Recall setup
Not saved 0
Usage
eventID = smu X .trigger.arm.stimulus
smu X .trigger.arm.stimulus = eventID
eventID Event that triggers the arm detector
X
Source-measure unit (SMU) channel (for example,
smua.trigger.arm.stimulus applies to SMU channel A)