Performance Verification 1-5
Restoring factory defaults
Before performing the verification procedures, restore the instrument to its factory front pan-
el (bench) defaults as follows:
1.
Press the MENU key. The instrument will display the following prompt:
MAIN MENU
SAVESETUP COMMUNICATION CAL
©
2.
Select SAVESETUP, then press ENTER. The unit then displays:
SAVESETUP MENU
GLOBAL SOURCE-MEMORY
3.
Select GLOBAL, then press ENTER. The unit then displays:
GLOBAL SETUP MENU
SAVE RESTORE POWERON RESET
4.
Select RESET, then press ENTER. The unit displays:
RESET ORIGINAL DFLTS
BENCH GPIB
5.
Select BENCH, then press ENTER to restore bench defaults.
Performing the verification test procedures
Test summary
•
DC voltage output accuracy
•
DC voltage measurement accuracy
•
DC current output accuracy
•
DC current measurement accuracy
•
Resistance measurement accuracy
If the Model 2430 is not within specifications and not under warranty, see the calibration pro-
cedures in Section 2 for information on calibrating the unit.
Test considerations
When performing the verification procedures:
•
Be sure to restore factory front panel defaults as previously outlined.
•
Make sure that the test equipment is properly warmed up and connected to the Model
2430 INPUT/OUTPUT jacks. Also be sure that the front panel jacks are selected with
the TERMINALS key.
Summary of Contents for SourceMeter 2430
