45
Command
Description
Default
param.
SCPI
[:EVENt]?
:ENABle <NRf>
:ENABle?
:CONDition?
:PRESet
:QUEue
[:NEXT]?
:ENABle <list>
:ENABle?
:DISable <list>
:DISable?
:CLEar
Read the event register.
Program the enable register.
Read the enable register.
Read the condition register.
Return status registers to default
states.
Path to access error queue:
Read the most recent error
message.
Specify error and status mes-
sages for queue.
Read the enabled messages.
Specify messages not to be
placed in queue.
Read the disabled messages.
Clears all messages from Error
Queue.
(Note 2)
(Note 3)
(Note 4)
(Note 5)
(Note 5)
√
√
√
√
√
√
√
√
√
Notes:
1.
Commands in this subsystem are not affected by *RST and
:SYSTem:PRESet. The effects of cycling power, *CLS and :STATus:PRESet, are
explained by the following notes.
2.
Event Registers: Power-up and *CLS – Clears all bits of the registers.
:STATus:PRESet – No effect.
3.
Enable Registers:Power-up and :STATus:PRESet – Clears all bits of the registers.
*CLS – No effect.
4.
Error Queue:
Power-up and *CLS – Clears the Error Queue.
:STATus:PRESet – No effect.
5.
Enable/Disable Error Queue Messages: Power-up – Clears list of messages.
*CLS and :STATus:PRESet – No effect
Table 12. SYSTem command summary
Command
Description
Default
param.
SCPI
:SYSTem
:PRESet
:POSetup <name>
:POSetup?
:FRSWitch?
:VERSion?
:ERRor?
:AZERo
:STATe <b>
:STATe?
Return to :SYST:PRES defaults.
Select power-on setup: (RST,
PRESet, or SAV0).
Query power-on setup.
Query INPUTS switch (0=rear,
1=front).
Query rev level of SCPI stan-
dard.
Query (read) Error Queue.
Path to set up autozero.
Enable or disable autozero.
Query autozero.
(Note)
ON
√
√
√
Table 11. STATus command summary (cont.)
