WES2HT User Manual
Manual-WES2HT-Rev1407-1
Copyright © KBC Networks 2013
Page 102 of 142
www.kbcnetworks.com
The Client default configuration is:
LAN MAC:
this is the unit’s own MAC address for the Ethernet LAN side of the device.
There are two MAC addresses per WES2HT unit; the radio also has its own MAC address
this can be found under the Radio 1 tab.
MODE:
this shows whether the unit is set to either a static IP address or DHCP in the
‘Basic Network’ menu.
IP ADDRESS:
this is the IP address of the unit. The addresses shown above are the
default IP addresses for the units.
GATEWAY IP ADDRESS:
this is the Gateway IP address shown under the Basic
Network setting menu. If access is required to the WES2HT unit from outside of the
network then this could be the router address. If the unit has the Topology function this
needs to be a pingable IP address on the network.
LAN cable:
this shows whether there is LAN cable connected or not.
11.2.1.5 Status: Radio 1 Tab
Details of the WES2HT unit accessed are recorded and appear on this status information
tab. If a connected WES2HT device is available on the RF link, its MAC address and other
link details will also appear. This page assists in providing critical details needed for
wireless link set up, trouble-shooting and/or maintenance.
