WES2HT User Manual
Manual-WES2HT-Rev1407-1
Copyright © KBC Networks 2013
Page 74 of 142
www.kbcnetworks.com
9.5.2 Client configuration for point-to-multipoint - EMEA
Step 1:
Remove the WES2HT Clients, Power Supply Units (PSUs) and Power
Injector Modules (PIMs) (for non-PoE units only) from the box.
Step 2a:
Connect the first Ethernet straight through cable from the ‘IN’ on the PIM
to either a laptop or a PC LAN port.
Connect the second Ethernet straight through cable from ‘OUT’ on the
same PIM to the WES2HT Host LAN port.
Apply power to the PIM with the provided 24Vdc PSU and allow 60 seconds
for the unit to boot up.
Step 2b:
The unit can also be powered via 802.3af PSE:
Connect an Ethernet cable from the PSE device (eg. Ethernet switch) to
the LAN port of the WES2HT unit.
Connect a second Ethernet cable from another port on the PSE to the
laptop or PC LAN port.
Apply power to the PSE device and allow 60 seconds for the unit to boot
up.
Step 3:
Set the static IP address on the laptop to the 192.168.1.x subnet.
