Kawamoto Pump RCD-40A0.75, Instruction Manual

Page: 27 / 28

27
Check item Failure criterion
Current
Voltage
Noise value/Vibration
Inside of a tank
Below the current value of a name plate.
Less than ±10% of rated voltage.
Are changeless from the first stage.
There is no clogged in the strainer of a pump.
※Please clean, when there is a jam.
８．１ Daily inspection,
Confirm the following check item at any time, and change care and the consumption part
as needed.
In order to discover abnormalities early, it is important to get to know a daily change.
We recommend to keep journal operation diary for that purpose.
Contents
９ Troubleshooting
●
If the pump does not run, or if there are any abnormalities , stop operation
immediately and turn the power source off. Contact your dealer or designated
service center for inspection and repairs
Warning
Check item
８．２ Periodic inspection
Dust, oil, etc. adhering to the surface are cleaned.
Remove chip precipitating in a tank base .
More than 1MΩ. Motor surface
Inside of a tank
Insulation resistance
Be careful when using solvent or similar to clean the pump. Inappropriate use of solvent may
result in poisoning. In addition, the use of thinner and/or benzine may cause a change or
abruption of painting color of the pump.
When there are any abnormalities after carrying out the check item of the following table,
please contact your dealer or designated service center.
The state of frequency Part name Replacement frequency
８．３ Consumable parts
When generation of heat, noise,
and unusual vibration occur.
When worn out.
When worn out.
When worn out.
Bearing
Bush
Sleeve
Impeller
About 2 years
−
−
−
If abnormal in daily maintenance and check, we will recommend you repair a little early.
The following parts are consumable parts. Refer to the replacement guidelines and replace the
parts.
Cause Countermeasure
Refer
page
Problem
The short circuit breaker is OFF.
Power supply problem.
The pump is connected with a
single-phase connection. Check the switch and power circuit.
Inspect and repair.
Correct the wiring
−
−
23
Pump does not run.