52 from 56
20
Special messages from the turntable
The following messages are shown on the screen to protect your reception system and the on-board power
supply:
The power supply to the turntable is inadequate (battery voltage below the minimum value)
.
This message means that the turntable can still be operated. However, communication errors between the
UFS 946/CI+ and the turntable can occur, for example, when searching for a satellite.
If the battery voltage drops further, then one of the following error messages appears:
Check the power supply to the turntable and
whether it is obstructed (e.g. by a branch). If nei-
ther of these causes of faults is displayed, the
turntable motor temperature is in the critical range.
Allow the turntable to stand for a few minutes in its
current position until the turntable motor tempera-
ture has reduced. You can also however move the
turntable to the park position and let it cool down
there.
Press the
button and the turntable moves to the
park position.
Press the
button to confirm the displayed mes
-
sage. The turntable cannot be moved any more.
Check the power supply to the turntable.
20.1
System protection messages
20.1.1
Undervoltage
Note
The antenna should not be moved whilst the battery is being recharged, to prevent peak loads when turn-
ing on.
20.1.2
Park position for safety reasons
The vehicle ignition was switched on. For safety rea-
sons, the turntable moves into the park position. This
operates however only if the green ignition cable for
the turntable is connected to the vehicle ignition and
the turntable is connected to the power supply! As
long as voltage is present at the ignition, the connec-
tion to the CAP will remain disabled. This means the
CAP cannot be operated.
