15 from 56
plate.
●
Allow the turntable to rest on the front edge of the mounting plate. Keep the turntable supported at an
angle (see Fig. E1) and insert a suitable piece of wood underneath it.
●
Now lay and connect the turntable cables in the mounting plate (as indicated on the mounting plate, see
Fig. E1). Take particular care that the two master coaxial cables, marked red, are connected to each
other. Initially tighten the coaxial cable plugs finger-tight, using no tools, then tighten them lightly using
an open-ended 11 AF spanner.
●
Now lower the turntable back on to the mounting plate, taking care whilst so doing that the cables are
fed through the cable gland and are not snagged.
● Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening
screws into the thread. Tighten the screws to a torque of 6 Nm.
Figure:
E1
Master coaxial cable
(marked red)
Figure:
E2
1
① = sealing gasket
